CNCRT 11: How to Set Up Constant Velocity Mode in Mach3

CNC Router Tips Podcast Episode 11:

How To Set Up Constant Velocity Mode in MACH3.
Q: Bill, I got a question about setting your Mach3 acceleration and Velocity setting in Mach3. Should I use Constant Velocity? I also wondered if the A axis and the Y axis settings have to be exactly the same?
Show Sponsor
The Makers Guide http://themakersguide.com
Links mentioned
International Podcast Day. #podcastday
http://cncroutertips.com/
http://cncroutertips.com/podcast
http://www.themakersguide.com/home/tutorials
http://www.themakersguide.com/home/products/mach3
http://cncroutertips.com/resources
http://themakersguide.com
htttp://cncroutertips.com/cncrt09
#podcastday
TERMS
Look ahead
Acceleration
Exact stop
Constant velocity
The lower the acceleration of the machine axis, the greater will be the radius of the rounded corner
How we do it:
In Mach3 you can set the velocity mode to either exact stop or Constant velocity. To do this go to General Configuration Logic the settings tab (page) and look for a button located above the Reset Button which says “Set Steps Per Unit”. Use this button to enter a distance to travel. Measure the actual distance traveled then enter the corrections.
Software:
If you would like to download a demo copy of Mach3, Check out this webpage. Go to http://www.themakersguide.com/machdemo